Korona 20355 Manuel D'instructions page 20

1. Open the lid (2) and hold the kettle (5) in an upright position
to fill it with water. Make sure to fill in the MIN amount of
water (0. 8 L) to avoid overheating.
The kettle can also be filled with water when the lid (2)
is closed by filling it through the spout (1).
2. Close the lid (2) and make sure it is properly closed.
3. Place the kettle (5) onto the base (8) and make sure it
properly fits onto the contact unit.
4. connect it to the mains and switch on the water kettle by
pressing the On/Off button (7). The integrated indicator
light (7) lights up.
5. As the heating respective boiling process starts the color
of the Hot logo (6) will change from black to color As soon
as the water boils, the appliance switches off automatically
provided that you have thoroughly closed the lid (2).
Otherwise boiling water could spill. The indicator light (7)
switches off as well.
6. Lift the kettle (5) off the base (8). The water is now ready
for use.
You can switch off the appliance resp. stop the boiling
process any time by simply pressing the On/Off button
upwards or by removing the kettle from the base.
Water left over from a previous boiling cycle can be re-used
in the next boiling cycle. However, always make sure that the
water level is not too low.
Always unplug the appliance after use.
Dry-boil cut-out
Your kettle is equipped with a boil-dry cut-out, which will
20