Whirlpool W9 OM2 4S1 H Manuel Du Propriétaire page 13

CLEANING AND MAINTENANCE
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If
any of these products inadvertently comes into
contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues To
dry any condensation that has formed as a result
of cooking foods with a high water content, let the
REPLACING THE LAMP
• Disconnect the oven from the power supply.
• Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
• Reconnect the oven to the power supply.
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
REMOVING AND REFITTING THE DOOR
• To remove the door, open it fully and lower the
catches until they are in the unlock position.
a
b
• Close the door as much as you can. Take a firm
hold of the door with both hands – do not hold it
by the handle.
Simply remove the door by continuing to close it
while pulling it upwards at the same time until it is
released from its seating. Put the door to one side,
resting it on a soft surface.
~15°
b
a
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
oven to cool completely and then wipe it with a
cloth or sponge.
• Activate the "Self-Clean" function for optimum
cleaning of the internal surfaces.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate
cleaning.
ACCESSORIES
• Soak the accessories in a washing-up liquid
solution after use, handling them with oven gloves
if they are still hot. Food residues can be removed
using a washing-up brush or a sponge.
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service. Do not handle bulbs with your bare hands as your
fingerprints could damage them. Do not use the oven until
the light cover has been refitted.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
• Lower the door and then open it fully. Lower the
catches into their original position: Make sure that
you lower them down completely.
• Apply gentle pressure to check that the catches
are in the correct position.
• Try closing the door and check to make sure that
it lines up with the control panel. If it does not,
repeat the steps above: The door could become
damaged if it does not work properly.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance work.
a
b
"CLICK"
EN
13