Publicité
Les langues disponibles
Les langues disponibles
Reinstall the ball stop.
8. Connect incoming air supply.
WARNING: The reel is under tension so use caution so that the
reel's latching mechanism does not release while adjusting the
tension.
HOSE REPLACEMENT
1. Disconnect the air supply and remove the leader hose from the
hose reel.
2. Remove the 2 piece ball stop by removing the 2 phillips head
screws, washers and nuts. Set aside.
3. Carefully pull all of the air hose from the hose reel until the clamp
that holds the hose to the hose reel drum is visable then make
sure the hose reel is locked
WARNING: The reel is under tension so do not turn the hose
reel drum or pull on the hose while it is locked.
4. Remove the hose clamp (located inside the hose reel drum - not
shown) and set aside.
5. Carefully disconnect the hose end (K) from the side of the hose
reel and remove the old hose.
6. Remove the hose protection spring (L) from the old hose. Place
the protection spring (L) on the new hose and then feed the hose
through the hose guide roller bracket and the slot on the drum
(M).
7. Apply thread seal tape to the hose threads and connect to the
hose reel (K) then tighten.
8. Attach the hose to the inside of the drum with the hose clamp.
Make sure the hose has a wide curve (N) to it and is not kinked
before tightening the hose clamp.
9. Make sure the hose protector spring (L) is in the correct location
(reference Figure 3).
10. Pull the hose to unlock and slowly rewind the air hose. Do not let
go of the hose.
11. Re-attach the ball stop to the desired location on the hose.
12. Reconnect the lead-in hose to the hose reel and turn on the air
supply. Check all connections to make sure there are no leaks.
SERVICE INFORMATION
Please have the following information available for all service calls:
Model Number _____________________________________________
Date and Place of Purchase _________________________________
8
Figure 3
Publicité
