BOMANN RG 6039 CB Mode D'emploi page 31

Intended Use
This appliance serves for heating, grilling and browning of
food.
It is intended for the use in private households and similar
applications. The appliance is only to be used as described
in the user manual. Do not use the appliance for any other
purpose.
Any other use is not intended and can result in damages or
personal injuries.
The manufacturer assumes no liability for damages caused
by improper use.
Scope of Delivery
1 × Grilling appliance
1 × Grill plate
8 × Small pans
8 × Wooden spatulas
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all packaging materials such as films, filler
material, cable clips and carton.
3. Check the contents for completeness.
4. In case of incomplete delivery or damage, do not operate
the appliance. Return it to your dealer immediately.
NOTE:
Production residue or dust may have collected on the ap-
pliance. We recommend cleaning the appliance according
to chapter "Cleaning".
Notes for Use
CAUTION:
Avoid damage to the non-stick coated grill surfaces!
• Only use wooden or teflon spatula.
• Do not use pointed objects (e.g. knife, fork) on the grill
surface.
• Do not use plastic utensils. They can melt.
• The non-stick coated grill surfaces enable dishes to be
prepared without the use of fat.
• If you want to use oil ensure that it is highly heatable,
such as sunflower oil. Do not use olive oil or butter, since
they start smoking already at low temperatures.
Assembly
• Place the grill plate onto the appliance so that it is held
firmly in place.
• Place the small pans underneath.
Electrical Connection
1. Please ensure that the temperature control is set to
position "0".
RG6039CB_IM
2. Before you plug the power plug into the power outlet,
ensure that the mains voltage corresponds with that of
the appliance. You can find information about this on the
rating plate.
3. Only connect the appliance to a properly installed
earthed socket. The red indicator lamp lights up continu-
ously and indicates the operating function.
Switching On / Off
The temperature control is used to switch the appliance on
and off. The green indicator lamp indicates that the appli-
ance is in operation.
Temperature Control
Adjust the temperature control depending on the intended
purpose:
• The MAX setting for grilling or roasting;
• a small or medium setting for keeping warm or cooking.
NOTE:
• Once the heat-up period is completed, the green
indicator lamp goes out.
• During operation the green indicator lamp will turn on
and off to maintain the temperature. This is normal and
indicates that the temperature is being thermostatically
controlled and maintained.
Before Initial Use
There is a protective layer covering the heating element,
which incinerates when the appliance is heating up. As a
result, there may be a small amount of smoke and odor
when using the appliance. However, this will subside after a
few times of use. This does not constitute a defect.
• You can minimize the smoke development by wiping the
heating element with a slightly moistened cloth before
using it for the first time.
• Do not use cleaning agents!
• Then wipe it with a dry cloth.
• Only switch on the appliance when it is in a completely
dry state.
• Always ensure adequate ventilation.
1. Slightly grease the small pans and the grill plate.
2. Put all the parts into the appliance.
3. Operate the appliance without food for about 10 minutes
for the protective layers to be removed. To do so, set the
temperature control to the position MAX.
4. Set the temperature control to position "0". Disconnect
the mains plug from the wall socket.
5. Let the appliance cool down completely.
6. Clean all the parts that will come into contact with food
again.
Your appliance is now ready to use.
31
15.07.20