KRESS KUB61 Mode D'emploi page 9

NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission
value:
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
L = 80.4 dB(A)
pA
3 dB(A)
L = 91.4 dB(A)
wA
3 dB(A)
a = 4.337 m/s 2
h
Uncertainty K = 1.5 m/s²
ACCESSORIES
Battery pack (KAB21)
Charger (KAC21)
Bit Clip
Hook
50mm screwdriver bit
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the
tool. Refer to the accessory packaging for further details.
Store personnel can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
This tool is intended for the fastening and loosening of
bolts, nuts and various threaded fasteners.
Assembly and Operation
ACTION
ASSEMBLY AND ADJUSTMENT
Assembling the Hook and Bit Clip
Inserting the bits
Removing the bits
OPERATION
Forward/reverse rotation control
Warning: The rotation direction of
machine cannot be change until it
is completely stationary.
KUB61 KUB61.91
2 /
1 /
1 1
1 1
1 1
FIGURE
See Fig.
A1,A2,A3,
A4
See Fig. B1
See Fig. B2
See Fig.
C1,C2,C3
9
EN