Publicité
Les langues disponibles
Les langues disponibles
6. Electrical work
TEMP.
ON/OFF
MENU
ON/OFF
FILTER
BACK
MONITOR/SET
DAY
CHECK
PAR-21MAA
CLOCK
OPERATION
CLEAR
Fig. 6-6
CHECK
ON/OFF
TEMP
FAN
AUTO STOP
MODE
VANE
AUTO START
CHECK
LOUVER
h
TEST RUN
min
SET
RESET
CLOCK
Fig. 6-7
Mode number
Setting number
Refrigerant address
Unit number
TEST
CHECK
CHECK
CHECK
CHECK
6.3. Function settings
6.3.1. Function setting on the unit (Selecting the unit functions)
1) For wired remote controller (Fig. 6-6)
Changing the power voltage setting
• Be sure to change the power voltage setting depending on the voltage used.
Go to the function setting mode.
Switch OFF the wired remote controller.
Press the FILTER
and TEST RUN
them for at least 2 seconds. FUNCTION will start to blink.
Use the
buttons to set the refrigerant address (3) to 00.
Press
button and [--] will start to blink in the unit number (4) display.
Use the
buttons to set the unit number (4) to 00.
Press the MODE button
to designate the refrigerant address/unit number. [--]
will blink in the mode number (1) display momentarily.
Press the
buttons to set the mode number (1) to 04.
Press the
button and the current set setting number (2) will blink.
Use the
button to switch the setting number in response to the power supply
voltage to be used.
Power supply voltage
230 V
: setting number = 1
208 V
: setting number = 2
Press the MODE button
and mode and the setting number (1) and (2) will
change to being on constantly and the contents of the setting can be confirmed.
Press the FILTER
and TEST RUN
seconds. The function selection screen will disappear momentarily and the air
conditioner OFF display will appear.
) For IR wireless remote controller (Fig. 6-)
Changing the power voltage setting
• Be sure to change the power voltage setting depending on the voltage used.
Going to the function select mode
CHECK
Press the
button
twice continuously.
(Start this operation from the status of IR wireless remote controller display turned
off.)
is lighted and "00" blinks.
CHECK
Press the
temp button
once to set "50". Direct the IR wireless remote control-
ler toward the receiver of the indoor unit and press the
Setting the unit number
Press the
temp buttons
and
wireless remote controller toward the receiver of the indoor unit and press the
button
.
Selecting a mode
Enter 04 to change the power voltage setting using the
. Direct the IR wireless remote controller toward the receiver of the indoor unit
and press the
h
button
.
Current setting number:
1 = 1 beep (one second)
2 = 2 beeps (one second each)
3 = 3 beeps (one second each)
Selecting the setting number
Use the
temp buttons
and
V). Direct the IR wireless remote controller toward the sensor of the indoor unit and
h
press the
button
.
To select multiple functions continuously
Repeat steps
and
to change multiple function settings continuously.
Complete function selection
Direct the IR wireless remote controller toward the sensor of the indoor unit and
press the
button
.
Note: Whenever changes are made to the function settings after installation
or maintenance, be sure to record the changes with a mark in the "Setting"
column of the Function table.
6.3.. Function setting on the remote controller
Refer to the appropriate operation manual included with each remote controller.
buttons simultaneously and hold
buttons simultaneously for at least two
h
button
.
to set the unit number "00". Direct the IR
temp buttons
to change the power voltage setting to 01 (240
min
and
Publicité
