Singer S14-88 Manuel D'instruction page 12

Threading the Upper Looper (Red)
When threading the upper looper, follow the thread path marked
with a red dot.
• Open the front cover. Raise the needle to highest position by
turning the hand wheel toward you. Raise the presser foot.
Pass the thread from back to front through the thread guide on
the thread stand (1). Use the tweezers to make the threading
easier.
• Pull the thread from right to left under the upper thread guide
(2).
• While holding the thread with both hands, pass it between the
tension discs and pull it down to make certain it is properly
placed between the tension discs (3).
• Thread the looper area of the machine following the red color
coded thread guides (4-6). Use the tweezers to make the
threading easier.
• Use the tweezers to bring the thread behind the lower looper
and thread into the hole in the upper looper from front to back
(7).
• Pull about 10cm (4") of thread through the looper and place it
to the back of the stitch plate.
8 – Getting Ready to Sew
English