Installation; Installing/Replacing The Lamps; Rigging - EuroLite RGB TL-150 DMX Mode D'emploi

INSTALLATION

Installing/Replacing the lamps

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation you need three 12 V/50 W GX-5.3 MR-16 lamps.
Procedure:
Step 1: Unscrew the 3 lower fixation screws of the top part of the housing.
Step 2: Remove the top part of the housing slowly and carefully.
Step 3: Remove the lamp-sockets from the lamps.
Step 4: Unscrew the fixation screw of the lamp holder.
Step 5: If replacing a lamp, remove the old lamp from the top part of the housing.
Step 6: Insert the 12 V/50 W GX-5,3 MR-16 lamps into the top part of the housing.
Step 7: Replace the lamp holder and tighten the screw.
Step 8: Replace the lamp-sockets onto the lamps.
Step 9: Replace the top part of the housing and tighten the screws.

Rigging

Install the device in a well-ventilated area. The operation in an unsufficiently ventilated room can lead to an
overheating of the device. The resulting overheating of the device can cause accidents. Keep a minimum
distance of 0.5 m around and above the device.
This device is only constructed for a standing installation.
This device may only be used as an integrated lighting fixture in 3-Point Trussing Systems with Quicklock.
DANGER TO LIFE!
Only install the lamps with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened top part of the housing!
20/47
CAUTION!
00025997.DOC, Version 1.2