ARDES AR5PR4000 Mode D'emploi page 17

Batteries
Remote control is supplied with battery inside (CR2025 type, 3V); remove
the transparent sheet from the battery cover before use remote control.
When the battery is over, it must be replaced with the same type.
To remove battery, follow the drawing on the back of remote control.
POWER Button (A):
Press this button when the unit is off, to turn it on.
Press this button when the unit is on, to turn it off.
SPEED Button (B):
Press this button when unit is on to select the desired speed from 1 to 6.
The display will show the selected speed.
MODE Button (C):
Press this button when unit is on to select the desired mode: natural
("NA" light in the display), sleeping mode (speed will decrease every 30
minutes and the "SL" light will turn on in the display) or normal (display
will show the ambient temperature).
TIMER Button (D):
When the unit is operating, you can set the timer to switch the fan off
automatically after the set time. Press this button repeatedly to select
the desired time period in one hour increments from 1 hour to 12 hours.
The display will show the setted time in hours. To deactivate the
timer function press timer button till the display will show the ambient
temperature or turn the fan off manually.
OSC Button (E):
Press this button when unit is on to activate the automatic oscillation from
left to right. "OS" indicator light will turn on in the display. To deactivate
the automatic oscillation press again this button.
NOTE: after a few seconds from pressing
the buttons, the display shows the room
temperature.
VERTICAL SLOPE:
You can vertically point the front of the fan
choosing the desired angle. It is sufficient to
move the front of the fan up or down according
to the desired slope.
17