Publicité
Les langues disponibles
Les langues disponibles
12
www.electrolux.com
Problem
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
8. INSTALLATION
8.1 Location
Refer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate
freely around the back of the cabinet.
8.2 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance.
Possible cause
The door has been
opened often.
3. Replace the used lamp with a new
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
7. Open the door.
Make sure that the light comes on.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Climate
class
SN
N
ST
T
Solution
Open the door only if neces‐
sary.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
socket.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Publicité
