Problem
Poor
atomisation
of
the
coating
material.
The motor is louder
than usual.
Unusual operating
noise.
Excessive
mist
formation.
Disposal
The packaging material is recyclable. Please dispose of it in an environmentally
friendly manner and take it to a recycling centre.
Dispose of the device in an environmentally friendly manner. It should not be
disposed of alongside general household waste. Dispose of it at a recycling
centre for used electrical and electronic devices. You can obtain more
information from your local authorities.
04545_de-en-fr-nl_V1.indb 35
04545_de-en-fr-nl_V1.indb 35
35
Possible cause / solution
•
The coating material is too runny. Check the viscosity (see
the "Preparing Coating Materials" chapter).
•
The coating material is too thick. Check the viscosity (see the
"Preparing Coating Materials" chapter).
•
The device is not clean. Clean the device (see the "Cleaning
and Maintenance" chapter).
•
The amount of paint is not set correctly. Turn the adjusting
screw (3) to regulate the amount of paint released.
•
The paint container (7) is almost empty. Refi ll it.
•
The coating material is too runny. Check the viscosity (see
the "Preparing Coating Materials" chapter).
•
The coating material is too thick. Check the viscosity (see the
"Preparing Coating Materials" chapter).
•
The wrong thinner has been used.
•
The paint spray gun is too far away from the surface. Move
closer.
Customer service / importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
(Calls subject to a charge. Costs
vary depending on the provider.)
EN
All rights reserved.
07.07.2015 11:53:42
07.07.2015 11:53:42