Test Symbols; Eu Declaration Of Conformity; Appliance Description; Settings And Displays - Stiebel Eltron DEL 18 Plus Utilisation Et Installation

Chauffe-eau instantané confort à régulation électronique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

oPErATIoN

Appliance description

Material losses
!
The user should protect the appliance and its tap against
frost.
2.3

Test symbols

See type plate on the appliance.
2.4

EU Declaration of Conformity

Note
STIEBEL ELTRON hereby declares that the radio equip-
ment type DEL Plus complies with Directive 2014/53/
EU. The full text of the EU Declaration of Conform-
ity can be found at the following internet address:
www.stiebel-eltron.de/downloads
3.
Appliance description
The appliance switches on automatically as soon as you open the
hot water valve on the tap. When you close the tap, the appliance
switches off again automatically.
The appliance heats water as it flows through it. The DHW outlet
temperature can be variably adjusted. From a certain flow rate,
the control unit regulates the correct heating output, subject to
the temperature selected and the current cold water temperature.
The electronically controlled instantaneous water heater with au-
tomatic output matching maintains a consistent outlet tempera-
ture. It is irrespective of the inlet temperature, up to the maximum
output of the appliance.
If the appliance is operated with preheated water and the inlet
temperature exceeds the selected set temperature, the word "hot"
and the inlet temperature are displayed alternately, and the "hot"
LED flashes. The water is not heated further.
You can save and quickly call up different temperatures. With
the ECO function, the flow rate is limited to 3 preset levels. The
appliance is equipped with functions to permanently limit the
temperature (e.g. for childproofing). The backlight switches on
automatically as soon as water starts to flow through the appli-
ance or you make a change on the user interface. The backlight
switches off automatically 5 seconds after water stops flowing or
if no operation has been performed for 30 seconds.
You can set the temperature unit and operating lock individually.
Heating system
The bare wire heating system is enclosed within a pressure-tested
plastic jacket. The heating system with its stainless steel heater
spiral is suitable for hard and soft water areas and is largely in-
susceptible to scale build-up. The heating system ensures rapid
and efficient DHW provision.
Note
The appliance is equipped with an air detector that large-
ly prevents damage to the heating system. If, during op-
eration, air is drawn into the appliance, the appliance
shuts down for one minute, thereby protecting the heat-
ing system.
www.stiebel-eltron.com
4.

Settings and displays

4.1

User interface

3
2
1
1 Temperature selector
2 "hot" scald warning LED, at temperatures higher than 43 °C
3 Temperature memory buttons 1 and 2
4 Display
5 ECO button with ECO level selection / Menu call-up
4.2

Display symbols

4
3
2
1
1 ECO indicator [rolling, levels 1 - 3, OFF]
2 Output bar [10 - 100 %]
3 Segment display [°C/°F]
4 In the event of an appliance fault, a spanner appears
5 Operating lock [ON/OFF]
6 Tmax, displayed when temperature limit is enabled
4
T
Tmax
5
5
T
6
Tmax
DEL Plus |
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Del 21 plusDel 24 plusDel 27 plus

Table des Matières