Publicité
Les langues disponibles
Les langues disponibles
and water utilities are as required. If not, call
an electrician and plumber to arrange the
utilities as necessary.
WARNING:
The manufacturer assumes no re-
sponsibility for any damages caused
by the work carried out by unauthor-
ized persons.
WARNING:
The product's power cable must be
unplugged during installation. Failure
to do so may result in death or seri-
ous injuries!
WARNING:
If the door span is too narrow for the
product to pass, remove the door
and turn the product sideways; if
this does not work, contact the au-
thorized service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar sources
of heat and at least 5 cm away from elec-
tric ovens.
• Do not expose the product to direct sun-
light or keep it in damp environments.
• Your product requires adequate air circu-
lation to function efficiently. If the product
will be placed in an alcove, remember to
leave at least 5 cm clearance between the
product and the ceiling, rear wall and the
side walls.
• Check if the rear wall clearance protection
component is present at its location (if
provided with the product).
• If the component is not available, or if it is
lost or fallen, position the product so that
at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance at
the rear is important for efficient operation
of the product.
4.2 Electrical Connection
Do not use extension or multi sock-
ets in power connection.
Damaged power cable must be re-
placed by Authorized Service.
When placing two coolers in adja-
cent position, leave at least 4 cm
distance between the two units.
• Our firm will not assume responsibility for
any damages due to usage without earth-
ing and power connection in compliance
with national regulations.
• The power cable plug must be easily ac-
cessible after installation.
• Do not use multi-group plug with or
without extension cable between the wall
socket and the refrigerator.
4.3 Attaching the Plastic Wedges
Use the plastic wedges provided with the
product to maintain sufficient space for air
circulation between the product and the wall.
1.
To attach the wedges, remove the
screws on the product and use the
screws provided with the wedges.
2.
Attach 2 plastic wedges on the ventila-
tion cover as shown in the figure.
EN / 13
EN
FR
DE
IT
Publicité
