Publicité
Les langues disponibles
Les langues disponibles
GB
KLG / KNG / SNG /PNG
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
3. Close the magazine slide (item 05) and
allow the catch lever (item 03) (if avail-
able) to engage.
Contact trigger (if available, see Techni-
cal data):
Contact trigger function when trigger lever
(item 02) pulled. Functions when tool is
pressurised.
or
Contact trigger function deactivated when
reversing lever actuated (item 13) (fig. 5a).
Tool is then depressurised.
Compressed air connection:
1. Install an upstream maintenance unit
with filter pressure reducer and mist oil-
er.
2. Press the quick-action coupling of the air
hose onto the plug nipple (item 01)
(Figure 1a).
Operation:
1. If
available:
(item 10)
2. Set the required pressure
3. If available: adjust the depth setting
(item 08) (Fig. 4a).
4. Place the trigger safety device (item 06)
or guide plate (item 07) onto the work-
piece and apply pressure firmly.
5. Press the trigger lever (item 02).
2.7
Troubleshooting
Observe the safety instructions and maintenance instructions!
Problem
A
Device
does
function
B
Compressed
escaping from the
opening
on
cover
II/ 10
release
the
interlock
Cause
not
Trigger lever (item 02) secured
with interlock (item 10)
Working pressure (flow pres-
sure) too low
air
O-ring or seal damaged or dirty
the
6. If available: contact trigger actuated
when trigger lever (item 02) pulled and
trigger safety device (item 06) placed on
the workpiece.
After use:
1. If available:
Secure the interlock (item 10).
2. Disconnect the quick-action coupling
from
the
plug
(Figure 1b).
3. Empty the magazine (item 04).
4. Clean the device dry with compressed
air.
5. Store the device in a secure location.
2.5
Maintenance
Regular lubrication is required!
Oil using a maintenance unit
with filter pressure reducer and mist oiler.
Add oil manually into the
plug nipple (item 01).
For long breaks in operation, also oil via
plug nipple (item 01) using special oil for
compressed air tools.
2.6
Decommissioning
Storage: Clean, dry, dust-free, not below
5° C.
Disposal: Dispose of the packaging / device
/ materials used according to applicable legal
regulations.
Remedy
Unlock the trigger lever (item 02)
(Fig. 4a)
Increase working pressure (flow
pressure)
working pressure
Contact
GmbH or an authorised service
****
partner.
nipple
(item 01)
Observe
maximum
*
Schneider
Druckluft
Publicité
