Publicité
Les langues disponibles
Les langues disponibles
WARNING
Penetration of thin workpieces or edges
possible!
Avoid or pay close attention!
CAUTION
Vibrations transmitted from tool to op-
erator during load operation.
Beware
Wear safety gloves
CAUTION
Dangerous obstacle!
Air hoses laid on the ground.
Avoid or pay close attention.
NOTICE
Do not use device for hard surfaces
such as concrete, metal or similar mate-
rials!
CAUTION
Triggering of fasteners
Do not use machines with a contact
trigger function:
on scaffolding, ladders and similar struc-
tures as well as work places that are only
accessible via ladders and scaffolding.
on inclined surface such as roofs.
when closing boxes and crates located on
a mobile surface.
when attaching transport locks on vehicles
and carriages, for example.
on unsecured, mobile or unstable surfac-
es.
KLG / KNG / SNG /PNG
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage,
financial
harm or risk of accident.
• Be calm and focused and ensure proper
operation.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
• Prohibited: manipulation, inappropriate
use, temporary repairs, use of other ener-
gy sources, removal or use of damaged
safety equipment, operating a leaking or
malfunctioning system, use of non-original
spare parts, exceeding the permitted
working pressure specified (max. + 10%),
working without protective equipment,
transporting / maintaining / repairing or
leaving a pressurised machine unattended,
using other / unsuitable lubricants, smok-
ing, naked flames, removing stickers.
• Prohibited: Use of fastening materials
other than those specified, storage with full
magazine.
• Prohibited: Touching trigger safety device
(item 06) or guide plate (item 07).
2.4
Commissioning
Before start-up:
1. Observe technical data, figures, item
numbers, intended use and safety in-
structions
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
2. Carry out a visual inspection.
3. Do not use below 5° C.
4. If supplied separately: attach plug nip-
ples (item 01).
Load fasteners:
1. Lift the catch lever (item 03) (if avail-
able) and open the magazine slide
(item 05) (Fig. 2a).
2. Load the correct fasteners into the bot-
tom / side / top-loading magazine
(item 04) (Fig. 3a).
GB
loss,
environmental
II/ 9
Publicité
