Publicité
Les langues disponibles
Les langues disponibles
USE
• Place the On/Off switch in position 1 to start the heater, the light comes on.
• The other two switches each control a 900W resistor. By turning on the two switches, we obtain a power of 1800W.
• Place the On/Off switch in position O to turn off the heater, the light goes off.
Adjust the thermostat :
Choose the heating
Place button on
power (900W or
max temperature.
1800W).
A thermal safety device automatically cuts the heating element in the event of overheating. To reset the
fireplace, disconnect the appliance from the mains supply for at least 5 minutes. Reconnect the supply to
the mains supply after fireplace cooled down, and fireplace will re-start working as before.
CARE
• Use a soft, dry cloth.
• For persistent stains, use a cloth dampened with soapy water and wipe immediately with a dry cloth.
TROUBLESHOOTING
Malfunctions are often due to minor causes; please read the table below before contacting the after-sales ser-
vice. This can save you time and avoid unnecessary expenses.
To replace the bulb, please contact our After-Sales Service.
(bulb 170-240VAC 50/60Hz, 5W)
40
40
40
40
40
40
40
40
30
30
30
30
30
30
30
30
20
20
20
20
20
20
20
20
10
10
10
10
10
10
10
10
0
0
0
0
0
0
0
0
-10
-10
-10
-10
-10
-10
-10
-10
Wait until the desired
Turn slowly the button
room temperature is
until the appliance
reached.
switches off.
53
Adjust the
On / Off
Thermostat
Enable
resistor 1
40
40
30
30
20
20
10
10
0
0
-10
-10
The appliance will heat as soon
as the room temperature drops to
maintain this set temperature.
EN
Enable
resistor 2
Publicité
