Rear Mounting (Reversible Mode) - Elica Rise 30 Guide D'utilisation, D'entretien Et D'installation

Rear mounting (reversible mode)

An optional aspiration assembly mounting position (opposite side)
for island cabinet locations. The aspiration assembly (metalic plate,
filters), can be moved to the opposite side (rear) of the vent.
D
A
A. Motor box
B. Aspiration orientation
1. Move the aspiration plate and the grease filters and put them
aside. (See the Cleaning section).
2. With the help of a flat head screwdriver, gently take off the
aspiration plate plastic clips.
3. Once the clips were removed from the aspration assembly, retire
the screws and washer as shown the image below. Put the
screws aside.
4.
NOTE: Once you have unplug the connector, cover it with the shrink-
able wire tube and the plastic ties as shows the image below. Set free
the opposite connector.
B
C
C. Cooktop
5.
D. Ensamble de aspiración
6.
NOTE: In order to properly align the structure, begin installing the
screws shown in the drawing.
7.
8.
9.
9
Unplug the aspiration assembly's electrical connection, and
remove it from the hood.
A.Plastic wire clip
B. Shrinkable wire tube
C. Aspiration assembly connection
Remove the mounting screws from the aspiration structure as
shown the image below.
A. Aspiration structure
B. Installation screws
Lift the structure and flip it to the opposite side and fix it with the
same screws previously removed.
A. Installation screws
Plug the electrical conexion and put it into place.
Put back the screws and metal washers to the aspiration
assembly. Insert the plastic clips back.
Relocate the grase filters and the aspiration plate.
A
B
C
B A
A