Publicité
Les langues disponibles
Les langues disponibles
ing operations. ROBAX S for slightly contaminated surfaces – a commercially avail-
able glass surface cleaning agent – may as well be used for the cleaning of the me-
dium or strongly contaminated glass surfaces of the fireplace. Towards this end, spray
small quantities of the agent to the cold surfaces, spread it, and wash it down with a
wet cloth, followed by drying with a clean, soft cloth. In case there are sticky fuel de-
posits on these surfaces, first scale simply them with a ceramic-plate scraper held in
flat angle, and then clean the surfaces as described above.
Cleaning of the ceramic surfaces dirt and grease are to be removed with soap and
water.
Cleaning of the soapstone: the soapstone is a natural stone, therefore minor colour
differences may occur; as it is normal, they may not serve as a basis for quality com-
plaints! To clean the soapstone from dirt and fat with water and soap, as well as small
scratches, use sand paper (grain size 240).
Warning: Under no circumstances you may use sponge, scouring, aggressive
or scratching cleaning agents! If the grate is blocked so that the equipment cannot
serve the intended function, the grate is to be removed for cleaning.
1.6 Potential problems and how to tackle them
Kind of operating
problem
Odour formation
Too little heating per-
formance
Possible reasons
Curing of the applied pre-
ventive lacquer.
Steaming oil remains.
We chose too little
•
performance
•
Chimney draught is
slight
Too long and leaky
•
smoke tube
23
Solution
Operate the fire-place on a
low heating level according
to the instructions manual
for a few hours. Then heat
up for maximal performance
for a few hours.
Have the heating re-
•
quirement of the room
examined by an expert
Chimney draught shall
•
be at least 12 Pa, max.
for a short time 15 Pa.
Check the tightness of
•
your chimney and also
that the doors of other
fire-places leading to
the same chimney are
closed and sealed
properly. Make sure
that the chimney-
cleaning joints are
sealed properly.
All the smoke tube
•
joints must be well
sealed and fireproof-
isolated
Publicité
