inventiv 739723 Notice De Montage page 39

B1
1
B2
1
ORIGINAL INSTRUCTIONS
2. ASSEMBLING/REPLACING THE DISC (GRINDING
DISC, METAL CUTTING DISC OR DIAMOND
CUTTING DISC)
WARNING! Do not touch grinding and cutting
discs before they have cooled down. The discs can
become very hot while working.
WARNING! Before undertaking any
maintenance, service, or changing a disc on the
grinder itself, remove the battery pack.
- Removing a disc
1) Clean the spindle and all parts to be mounted.
2) Press and hold the spindle lock button to lock
the spindle. You may need to rotate the spindle
using the provided hex key if the spindle lock button
cannot be pressed down fully.
3) Loosen the clamping bolt with washer by turning it
anti-clockwise using the provided hex key.
4) Remove the clamping bolt with washer and the
disc. (See Fig. B1)
WARNING! Press the spindle lock button
only when the grinder spindle is at a standstill.
2
Otherwise, the mini grinder may become damaged.
- Fitting a disc
NOTE: When fitting a disc for the first time, follow
steps 2 - 4 above before applying the disc.
1) Place the disc on the tool spindle. Ensure it is
correctly located.
NOTE: When installing the grinding disc, make
sure that the convex surface is facing up.
2) Insert the clamping bolt with washer through
2
the centre of the disc and onto the spindle.
3) Press and hold the spindle lock button to lock the
spindle. You may need to rotate the spindle using
the provided hex key if the spindle lock button
cannot be pressed down fully.
4) Tighten the clamping bolt with washer by turning it
clockwise using the provided hex key. Make
sure that the cutting disc/grinding disc is assembled
firmly. (See Fig. B2)
WARNING! After mounting the grinding/ cutting
disc and before switching on, check that the disc is
correctly mounted and that it can turn freely. Make
sure that the disc does not graze against the wheel
guard or other parts.
39
SAFETY AND OPERATING MANUAL