Publicité
Les langues disponibles
Les langues disponibles
Important safety information
•
Electrical service to the range must conform to local codes. Barring local
codes, it should meet the latest ANSI/NFPA No. 70 – Latest Revision (for the
U.S.) or the Canadian Electrical Code CSA C22.1 – Latest Revisions.
•
It is the personal responsibility of the range owner to provide the correct
electrical service for this range.
Installation safety
WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, observe
the following precautions.
•
Do not attempt to service, modify, or replace your range or any part of your
range unless it is specifically recommended in this manual. All other service
should be referred to a qualified technician.
Always use new flexible connectors when installing a gas appliance. Do not
•
use old flexible connectors.
•
Make sure the anti-tip device is properly installed on the range. See the
installation instructions for more information.
•
Due to the size and weight of the range, have two or more people move the
range.
•
Remove all tape and packaging materials.
•
Remove all accessories from the cooktop, oven, and/or lower drawer. Grates
are heavy. Use caution when handling them.
•
Make sure no parts came loose during shipping. Do not install in an area
exposed to dripping water or outside weather conditions.
10 English
DOP36T86DLS_DA_DG68-01105G-00_EN+MES+CFR.indb 10
DOP36T86DLS_DA_DG68-01105G-00_EN+MES+CFR.indb 10
•
Have your range installed and properly
grounded by a qualified installer,
in accordance with the installation
instructions. Any adjustment and
service should be performed only by
qualified gas range installers or service
technicians.
•
Make sure your range is correctly installed and adjusted by a qualified service
technician or installer for the type of gas (natural or LP) you will use. For
your range to utilize LP gas, the installer must replace the 5 surface burner
orifices and 2 oven orifices with the provided LP orifice set, and reverse
the GPR adapter. These adjustments must be made by a qualified service
technician in accordance with the manufacturer's instructions and all codes
and requirements of the authority having jurisdiction. The qualified agency
performing this work assumes the gas conversion responsibility.
•
Installation of this range must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition. In Canada, installation must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1, or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where applicable. This range has been
design-certified by ETL according to ANSI Z21.1, latest edition, and Canadian
Gas Association according to CAN/CGA-1.1, latest edition.
Location safety
WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, observe
the following precautions.
•
•
This range is for indoor, household use
only.
Do not install the range in areas
exposed to the weather and/or water.
Do not install the range in a place
which is exposed to a strong draft.
2023-02-28 오전 9:51:19
2023-02-28 오전 9:51:19
Publicité
