Publicité
Les langues disponibles
Les langues disponibles
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Displays
do not illuminate.
Temperature display
indicates "E..".
The light
does not function.
Possible cause
Power failure; the fuse
has been switched off;
the mains plug has
not been inserted
properly.
Electronics have
detected a fault.
The LED light
is defective.
Appliance was open
too long.
Light is switched off
after approx. 10 min.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether the
temperature has approached the
set value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether
the power is on, check the fuses.
Call customer service.
See chapter "Light (LED)" section.
When the appliance is closed and
opened, the light is on again.
en
39
Publicité
