Atag KD8178BF Instructions D'utilisation Et De Montage page 40

Control
w The Fast Freeze button flashes. The display indicates c.
u To confirm, briefly press the Fast Freeze button
u To switch on: Using the "+" setting button, freezer
Fig. 2 (5) or "-" setting button, freezer
compartment
Fig. 2 (4) , select c1.
compartment
u To switch off: Using the "+" setting button, freezer
Fig. 2 (5) or "-" setting button, freezer
compartment
Fig. 2 (4) , selectc0.
compartment
u To confirm: Press the Fast Freeze button
Fig. 2 (2) .
w When the child lock symbol
is activated.
u To deactivate the setting mode: Press On/Off button, freezer
Fig. 2 (3) .
compartment
-or-
u Wait for 5 minutes.
w The temperature is indicated again in the temperature
display.
5.3 Door alarm
If the door is open longer then 60 s, the audible alarm sounds.
The audible alarm is automatically silenced when the door is
closed.
5.3.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
Fig. 2 (1) .
u Press alarm button
w The door alarm is silenced.
5.4 Temperature alarm
The audible alarm sounds if the freezer temperature is not cold
enough.
The temperature display flashes at the same time.
The cause of the temperature being too high may be:
warm fresh food was placed inside
-
- too much warm ambient air flowed in when rearranging and
removing food
- power failure for some time
- the appliance is faulty
The audible alarm is automatically silenced and the tempera-
ture display stops flashing when the temperature is sufficiently
cold again.
If the alarm status persists: (see Malfunction).
Note
Food may be spoilt if the temperature is not cold enough.
u Check the quality of the food. Do not consume spoiled food.
5.4.1 Muting the temperature alarm
The audible alarm can be muted. When the temperature is
sufficiently cold again, the alarm function is active again.
u Press alarm button Fig. 2 (1) .
w The audible alarm is silenced.
5.5 Refrigerator compartment
The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the plate separating off the ClimatFreshbox zone and at
the rear wall. It is warmest at the top front of the compartment
and in the door.
40
Fig. 2 (2) .
Fig. 2 (8) shines, the child lock
5.5.1 Food refrigeration
u Place butter and preserves in the upper area and in the door
(see Appliance at a glance).
u Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
u Do not store food too close together to enable good air
circulation.
u To safeguard bottles from tipping over: move the bottle
holder.
5.5.2 Setting the temperature
The temperature can be set from 9 °C to 4 °C, the recom-
mended temperature is 5 °C.
Note
If the temperature is to be colder than 4 °C:
u set the cooling temperature to 4 °C.
u Set the ClimatFreshbox temperature to a value between b4
(slightly colder) and b1 (coldest) .
u For a higher temperature setting: press "+" "+" button, refrig-
Fig. 2 (10) .
erator compartment
u For a lower temperature setting: press "-" button, refrigerator
Fig. 2 (9) .
compartment
w The first time the button is pressed, the value set so far is
indicated in the refrigerator compartment temperature
display.
u To change the temperature in 1 °C steps: briefly press the
button.
u To change the temperature continuously: hold down the
button.
w The value is displayed flashing during the setting operation.
w The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.5.3 Fast Cool
Use Fast Cool to activate the highest cooling performance to
reach lower cooling temperatures. Fast Cool is used for rapidly
cooling large amounts of food.
Fast Cool has a slightly higher energy consumption
To cool using Fast Cool
u Briefly press the Fast Cool button
w The cooling temperature drops to the coldest value. Fast
Cool is switched on.
w Fast Cool switches off automatically after approx. 6 hours.
The appliance continues to operate in the energy-saving,
normal mode.
To switch off Fast Cool ahead of time
u Briefly press the Fast Cool button
w Fast Cool is switched off.
5.5.4 Relocating the shelves
The shelves have stops preventing them from being uninten-
tionally pulled out.
Fig. 2 (12) .
Fig. 2 (12) .