Johnson JWASH Serie Guide D'utilisation page 69

Type 2: Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only
one single work top under which cabinets
and electrical appliances are fitted. In this
case remove the work top of the
dishwasher by unscrewing the screws
under the rear edge of the top (a).
Attention
After removing the work top, the screws must be screwed again
under the rear edge of the top (b).
The height will then be reduced to 815 mm, as scheduled by the
International Regulations (ISO) and the dishwasher will fit
perfectly under the kitchen working top.
Built-In Installation(for the integrated model
Step 1. Selecting the best location for the dishwasher
The installation position of the dishwasher should be near the existing inlet
and drain hose and power cord. Illustrations of cabinet dimensions and
installation position of the dishwasher.
1. Less than 5 mm between the top of dishwasher and cabinet and the
outer door aligned to cabinet.
90 °
Electrical, drain
and water supply
820mm 00 line connection
580 580mm
Space between
cabinet bottom
and floor
600 mm (for 60cm model)
450 mm (for 45 cm model)
21
90 °
8 80
100
a
a
b
b
V.1