Kiva D3 87ESM Notice D'utilisation page 33

To be performed by an approved workshop
i) Adjusting the travel of the blade
Check after any violent shocks. Adjust when you dismantle the universal joint.
POSITIONING THE PLATE AT DEAD CENTRE:
Turn the plate by hand until the axis of the universal joint is at the top
SLACKENING THE 2 BOLTS OF THE UNIVERSAL JOINT:
Slacken the two M10 bolts of the universal joint
POSITIONING THE SECTIONS OF THE BLADE:
By turning the rocker bar at the end (one side or the other), slide the blade so that
the cutting sections are positioned part-way between the fingers,(equal to one
step).
- With the bar and the machine horizontal, when altering the position of the blade,
check that a section A initially occupies a median position 1 between your fingers
in order to occupy a similar position 2 at the limit switch. In other words, positions
1 and 2 correspond to the extreme positions for moving the blade.
13 EN