Philips sonicare 3000 Serie Mode D'emploi page 10

10
English
Brushing instructions
1
2
4
3
Please follow brushing instructions below for the best
experience. To help you transition to your new Sonicare
power toothbrush, it comes with the EasyStart feature
turned on. This feature gently increases the power over
the first 14 brushings to help you adapt to brushing with
a Philips Sonicare toothbrush.
1 Wet the bristles and apply a small amount of
toothpaste.
2 Place the toothbrush bristles against the teeth at a
slight angle (45 degrees), pressing gently to make the
bristles reach the gumline or slightly beneath the
gumline.
Note: Keep the center of the brush in contact with the
teeth at all times.
3 Press the power on/off button to turn on the Philips
Sonicare.
4 Gently keep the bristles placed on the teeth and in the
gumline. Brush your teeth with small back and forth
motion so the bristles reach between the teeth.
Continue this motion throughout your brushing cycle.
Note: The bristles should slightly flare. It is not
recommended to scrub as you would with a manual
toothbrush.
5 To clean the inside surfaces of the front teeth, tilt the
brush handle semi-upright and make several vertical
overlapping brushing strokes on each tooth.
Note: To make sure you brush evenly throughout the
mouth, divide your mouth into 4 sections using the
QuadPacer feature (see chapter 'Features').
6 Begin brushing in section 1 (outside upper teeth) and
brush for 30 seconds before you move to section 2
(inside upper teeth). Continue brushing in section 3
(outside lower teeth) and brush for 30 seconds before
you move to section 4 (inside lower teeth).