Connection To Power Supply - KRONAsteel JESSICA Guide De L'utilisateur

EN Application sheet
2. Put one end of the flexible duct with a diameter
of 120 mm (not included in the delivery set) on
the adapter flange and secure it with a clamp
(not included in the delivery set). Non-return
valve prevents air from entering the ventilation
shaft into the kitchen.
3. Attach the hood with four screws to the wall
drawer with the supplied fasteners, before
that laying a flexible air duct through it. To re-
duce vibration and noise, it is desirable to lay
insulating material between the hood and the
drawer.
4. Connect the other end of the flexible duct to
the ventilation hole in the wall. The shorter and
more straight the flex duct is, the higher the
output and the less noise and vibration at the
hood.
If the hood operates in recirculation mode, then
the markings for the opening for the flexible duct
should not be made. Install the coal filter on the
hood, set the damper to the recirculation position
and attach the hood to the drawer.
KITCHEN HOODS

CONNECTION TO POWER SUPPLY

The kitchen hood is connected to the power net-
work with the voltage of 220-240V, 50 Hz.
The kitchen hood should be connected to a wall
outlet with earthing to avoid electrocution.
It is absolutely prohibited to cut off the plug
during kitchen hood installation.
The damaged electrical cord should be re-
placed by a qualified service specialist.
For additional protection of the kitchen hood from
voltage drops in the network, connect it though an
additional automatic switch 6A.
Switch it on and use it as you please.
The kitchen hood is installed.
11