Atag VA6311QF Notice D'utilisation page 70

70
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
Use of combi detergent tablets
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
Select and start a washing programme
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate
2. Check that the water tap is opened
3. Close the dishwasher door.
4. Turn the programme knob until the pro-
gramme marker corresponds with the
desired programme (see "Washing pro-
grammes" chart).
– The On/Off indicator light comes on.
– The indicator lights of the phases fore-
seen for the programme start flashing.
5. Press the start/cancel button. The pro-
gramme starts automatically and the
start/cancel indicator light comes on.
– As soon as the programme starts, the
phase indicator lights go off except for
the indicator light for the phase in pro-
gress which will remain on with a static
light.
depending on which kind of tablets you
choose ('3 in 1', '4 in 1', '5 in 1' etc.).
1. Check whether these detergents are suit-
able for your water hardness. See the
manufacturers instructions.
The refilling of the salt container and the
rinse aid dispenser are no longer neces-
sary. In this case the rinse aid indicator
light will always remain on when the ma-
chine is switched on.
2. Select the lowest setting for water hard-
ness and rinse aid dosage.
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser with rinse
aid.
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal
washing programme without loading any
dishes.
3. Adjust the water hardness setting ac-
cording to the hardness of the water in
your area.
4. Adjust the rinse aid dosage.
During the running of the programme, it
is not possible to change the selection
made by turning the programme knob in
correspondence of another programme
or the Off position. If you want to change
the running programme you must cancel
the selection made (see "Cancel a wash-
ing programme in progress").
The washing programme will begin only
after having pressed the start/cancel
button. Until that moment it is possible
to modify the selection made.
Select and start a washing programme
with delay start
Allows the start of the washing programme
to be delayed by 3 hours.
1. Select a washing programme.
2. Press the delay start button. The delay
start indicator light comes on.