Atag VA6311QF Notice D'utilisation page 65

2. Keep the start/cancel button pressed
and turn the programme knob clockwise
until the programme marker corresponds
with the first washing programme.
3. Release the start/cancel button. The On/
Off indicator light and the start/cancel in-
dicator light start to flash. This means that
you have activated the water softener
setting function.
4. Simultaneously the End indicator light
starts to flash.
The current level is indicated by the num-
ber of flashes of the End indicator light
and a pause of about 3 seconds.
Examples:
Use of dishwasher salt
Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
ener. Only fill with salt just before starting one
of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
To fill:
1. Open the door, remove the lower basket
and unscrew the cap of the salt container
by turning it anticlockwise.
2. Pour 1 litre of water into the container
(this is necessary only before filling
with salt for the first time) .
3. Using the funnel provided, pour in the salt
until the container is full.
5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6
5. To change the level, press the start/can-
cel button. Each time the button is press-
ed the level changes.
Examples:
if the current level is 5, by pressing start/
cancel button once, level 6 is selected.
if the current level is 10, by pressing start/
cancel button once, level 1 is selected.
6. To memorize the operation, switch off the
dishwasher by returning the programme
knob to the Off position.
4. Replace the cap making sure that there
is no trace of salt on the screw thread or
on the gasket.
5. Replace the cap tightly turning it clock-
wise until it stops with a click.
Do not worry if water overflows from the
unit when filling with salt, this is quite
normal.
The salt indicator light on the control
panel can remain illuminated for 2-6
hours after the salt has been replen-
ished, assuming the dishwasher re-
mains switched on. If you are using
salt that takes longer to dissolve
then this can take longer. The oper-
ation of the machine is not affected.
65