VOLTOMAT HEATING FH-106145.3 Mode D'emploi page 77

FH-106145.3 & FH-106145.4
PARTS DESCRIPTION
1. Indicator light
2. Thermostat control switch
3. Heat select switch
4. Air outlet grille
Heat setting:
"O"position – OFF
" " – FAN
I = WARM AIR (low heat output)
II = WARM AIR (high heat output)
THERMOSTAT
1. Rotate the switch to choose the suitable setting ("
heat output).
2. Turn the thermostat knob in a clockwise direction to the max position.
3. Once the room temperature has reached the desired value, turn the thermostat knob slowly in
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
4. The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting, and switch off if it is above the setting.
Note: To switch off the appliance, it is recommended to turn the heat switch to fan setting for about 15
seconds to cool down. After that, please turn the heat switch to "O" position and then unplug the appliance.
This can help prolong the lifespan of the appliance.
SAFETY SYSTEM
The appliance has a safety system which automatically switches off the unit when overheated.

If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down for

at least 30 minutes. Put the plug in the socket and switch on the heater.
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will automatically

switch off the power if it is put on unstable or uneven surfaces or if it is tilted accidentally.
MAINTENANCE
The fan heater only needs regular cleaning on the outside.

Before you clean the unit, turn off the switch. Remove the plug from the socket and wait until the fan

heater cools down completely.
Use a damp cloth to wipe the heater housing.

Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the

appliance.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 1800W
"= fan only, no heat/ "I"= low heat output/"II"= high
- 76 -
GB