Kobe Range Hoods Brillia Série Manuel D'installation Et Mode D'emploi page 9

Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
Decide the location of the venting pipe from the
hood to the outside. (Figure 1)
A straight, short venting run will allow the hood to
perform more efficiently.
Try to avoid as many transitions, elbows, and long
run as possible. This may reduce the performance
of the hood.
Temporarily wire the hood to test for proper
operation before installing
Important: Peel protective film off the hood and
the duct cover (if any).
If necessary, prepare back wall frame with cross
framing lumber for secure installation. Refer to
Table 1 and measurements on Page 14 to decide
the level of the lumber. (Figure 2)
Loosen hood-mounting brackets at the back of the
hood, adjust brackets and tighten screws.
If necessary, remove the rubber stand on the back
of the hood. (Figure 3)
Figure 1
Figure 2
Figure 3
7