Hitachi PC-RLH13 Manuel D'installation Et De Fonctionnement page 8

2
OPERATION & INSTALLATION MANUAL FOR PC-RLH13
3 INSTALLATION OF WIRELESS RECEIVER KIT

CAUTION:
Pay attention to the following installation procedures. If not, it may drop from the panel,
resulting in a serious accident.
1) Install the wireless receiver kit, the indoor unit and the air panel at the same time.
2) In case that the wireless receiver kit is installed after installing the indoor unit, turn off the power
source of the indoor unit and remove the air panel.
3) This receiver kit can be installed only at one position
(Drawing: without suction grill)
The installation position
Electrical control box
4) Remove the cover of indoor unit electrical controlbox and connect the cable to the terminal
board (white) as shown below.
Connecting Cable
Pipe connecting side
Wiring hole
Terminal Board
Indoor Unit Electrical control box
Mark Band "B"
Mark Band "A"
(White)
PCB