Urmet sinthesi steel 1158/45 Mode D'emploi page 12

COMPLETE RESET OF THE MEMORY
The entire contents of the memory can be
deleted, for example to re-use the device in a new
installation.
In the case of a complete memory reset, the
password and all the user keys held in the memory
are deleted.
Proceed as follows:
− switch off the device.
− press the rear red button and, holding it down,
switch on the device again.
− hold the button down until the following caption
is cleared:
At this point, the display will start a count-down,
clearing the user key memory.
− release the button.
− wait for the end of the count and return to normal
functioning.
HOW TO REPLACE A FAULTY DEVICE
To replace a faulty device, the key memory must be
moved from one module to another to avoid having
to reprogram the user keys.
Proceed as follows:
− switch off the faulty module.
− open the rear cover and carefully extract the
memory device exerting leverage on both sides
with a small screwdriver.
− insert the memory device in the new module,
powered off, paying particular attention to the
direction of insertion as shown in the figure.
1
HOW TO STORE MORE THAN 500
USER KEYS
In particular applications, it may be necessary to
store more than 00 user keys.
In this case, use the 110/ (000 keys) memory.
Replace the standard key memory with the new
memory, proceeding as follows:
− switch off the door opener module;
− open the rear cover and carefully extract the
standard memory device, exerting leverage on
both sides with a small screwdriver;
− insert the new memory device, paying particular
attention to the direction of insertion, as shown
in the figure;
− switch on the module again.
At power-up, the door release module automatically
recognizes the higher capacity memory without
requiring any further operations.
§
In this case, the decimal points are used
to distinguish the keys with number
above 999; the right-hand decimal
point will indicate keys between 1000
and 1999; the central decimal point will
indicate keys between 2000 and 2999.
For example:
key No. 0
key No. 10
key No. 070
DS1148-001