Costway JV10936 Instructions De Montage page 6

ASSEMBLY INSTRUCTIONS
1. Place a leg frame(B)upside down on a non-abrasive surface
such as carpet, attach two crossbars(C) to the leg frame(B) by
inserting the crossbar into the holes on the leg frame (B) as
pictured (a) & use wood glue(6) to secure crossbars(C) to the leg
frame(B).
Note: The small holes on the bottom of the crossbars must
face the bottom of the stool.
2. Repeat the same above steps by attaching the second leg
frame to the crossbar as shown.
3. Using the wood glue, glue the wood dowels into each of the 4
holes on the top of the bar stool legs (where the seat will be
attached.) Fill hole with glue until approx 1/4 full insert the dowel
and wipe away excess glue. Wait until the glue dries and the
dowel is securely attached before attaching the seat. Once dry,
place the seat on the dowels, lining up the seat holes so the
dowels fit inside the holes and the seat sits flat to secure the
frame to the seat cushion using four Allen bolts(1), four flat
washers(2), and four spring washers (3) as pictured(b). Tightly
fasten the Allen bolts with Allen wrench(5).
06