Garland 880 QG Manuel D'instructions page 37

Fig.2
Place the security switch as shown in the diagram
over the top of the two chutes and hold in place using
the two long screws.
Long screws
Security switch
37/184
Once in place, tighten the security screws of the chute
and exit tube (fi g 1 and fi g 2).
ATTENTION: When dismounting the chute and exit
tube, always remove the security switch.
6.2.3. MOUNTING THE TENSION PULLEY OF THE BELT
Remove the holding seal of the cotter being careful
that it does not fall out.
Chaveta
Place the tension pulley as shown in the diagram and
tighten the screw.
ATTENTION: Before placing the pulley in place,
make sure that the cotter is in place.
English
Precinto