Hatco RHW Série Manuel D'installation Et D'utilisation page 7

English
3. Guide the control box with the front cover removed and the
electrical cords through the countertop cutout, and then
lower the unit into the cutout.
Control Screw
Box
HATCO CORPOR
ATION www.ha tcocorp. MILWAU
Front com KEE, WI U.S.A.
Cover
Control Box
Cutout
Installing the Unit
4. assemble the L-brackets to the
underside of the unit.
5. Tighten the L-bracket screws until
the top flange lies flat on the
countertop.
NOTICE
Do not use excessive force when
tightening mounting screws on
built-in units. This may damage unit
and/or countertop.
Form No. RHWm-0816
Countertop
Cutout
Countertop
Top Flange
Screw Screw
L Bracket L Bracket
7
6. Install the control box in the control box cutout:
a. Pass one of the mounting flanges on the control box
housing through the cutout. Tilt and slide the other
flange through the cutout.
b. align the holes on the mounting flanges with the screw
holes in the installation surface, and secure the control
box housing to the surface using four screws (not
supplied).
c. Install the front cover on the control box using the four
front cover screws.
Control Box
Front
Cover
HAT CO COR
POR ATI ON
ww w.h
atco MIL WA
cor p.co UKE E, WI
m U.S .A.
Front Cover
Screws
Installing the Remote mounted Control Box
7. Plug the power cord into a properly grounded electrical
outlet of the correct voltage, size, and plug configuration.
See the SPECIFICaTIONS section for details.
INSTALLATION
Housing
Mounting Flange