Craftmade CD52 Mode D'emploi page 5

8
1. Connect fan wires to ceiling wires: white fan wire to white outlet
wire, black to black and green to green. Wire connectors (S6) are
provided for your convenience. If an additional blue wire is present then
also connect the blue wire to the black wire. (Optional light kit may be
wired to individual wall switches, if desired.)
2. After connections
are made, turn
Ground
splices upward
and push carefully
White (Neutral)
into outlet box.
Separate blue and
Black (Power)
black wires on one
side of the box, and
white and green wires
on the other side.
There are 4 colored
wires coming from the
top of the motor
(including ground wire).
Wire Connnections
Outlet Box Fan wires
Black Black
(Hot wire for fan)
Green Green
(Ground wire)
White White
(Neutral wire)
Black Blue
(Light kit wire)
Step 8
White
Black
Blue
Outlet Box
Ground (Green)
Downrod Ground
(Green)
Mounting Bracket
Ground (Green)
9
Attach canopy (3) to the
mounting bracket by placing
screws (S2) into slot in
canopy. Twist clockwise to
lock into place. Tighten
screws firmly.
Wire
Connectors
(S6)
Ground
(Green)
10
For blade assembly, position blade holder (6), blade (7) so that all
screw holes are aligned (as shown in figure below). Using blade
screws (S4), insert through top of blade holder, through blade, and
into blade ornament. Tighten securely.
Blade Holder
Screws (S5)
CAUTION:
Install blade holders to motor only after motor installation is complete. This
will prevent damage to the blade holders which have been carefully balanced.
IMPORTANT: Remove rubber cushions, saving motor screws for installation.
Step 9
Step 10
Blade Screws (S4)
Blade Arm (6)
Ceiling
Canopy (3)
Screws (S2)
Bottom of Canopy
Blade (7)