Publicité
Les langues disponibles
Les langues disponibles
EN
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO
WARM (REMOVE FOR
APPROX. 30 MINUTES TO
ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY
(REMOVE AND REPLACE
WITH A NEW BATTERY)
1. Put the battery pack into the charger.
•
If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
•
If the status LEDs show correct, the battery pack is
good.
•
If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
•
If the status LEDs show correct, the battery pack is
good.
•
If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
6.2
EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6 ˚C and 40˚C .
English
3
RED
RED
RED
GREEN
OR-
RED
ANGE
RED
OFF
RED
RED
BLINKING
WARNING
If you put the battery pack into the charger in warm or hot
environment, the charger LED light is red. Pull out the
battery pack and let the battery cool for approximately 30
minutes.
6.3
MOUNT THE CHARGER
1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood
studs.
3. For charger CAG801/2903102/29862: Drill two
paralleled holes 5" (127 mm) on center. For charger
CAG812/CAG817: Drill two paralleled holes 4.4" (112
mm) on center.
4. Use wall anchors and screws to attach the charger to the
drywall.
CAG801/2903102/29862
CAG812/CAG817
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
7
MAINTENANCE
7.1
CLEAN THE MACHINE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or put the air flow in water.
•
Clear the unwanted material out of the air vent with a
vacuum.
•
Clean housing and the plastic components with a dry and
soft cloth.
6
NOTE
NOTE
Publicité
