Atag VA8215SLR Notice D'utilisation page 216

Installation
It is important that you read through and follow the instructions and directions below. Conduct
installation and connection in accordance with the separate installation instructions.
[mm]
*Remove the locking nuts when installing in a recess measuring 860-861 mm.
** Cover door length.
Cover door with slide function fitted, which means the cover door
slides upwards/outwards when the dishwasher is opened.
Safety instructions
Connections to electricity, water and drainage must be performed by a qualified professional.
Always follow applicable regulations for water, drainage and electricity.
Take care during installation! Wear protective gloves! There must always be two people!
Place a drip tray on the floor beneath the dishwasher to prevent damage from any water leaks.
Before screwing the dishwasher into place, test the dishwasher by running the Rinse and hold
program. Check that the dishwasher fills with water and drains. Check also that none of the
connections leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the socket turned off while the work is carried out!
Setup
The recess and connection dimensions are included in the separate installation instructions.
Check that all dimensions are correct before starting the installation. Note that the height of the
cover door can be adjusted to match other fittings.
Handle the front corners of the dishwasher with care so that they do not get bent, which can
affect door opening.
48
Nominal dimensions. Actual measurements may vary.