Atag VA8215SLR Notice D'utilisation page 199

Settings
9. Water hardness
10. TAB
11. Auto dose
12. Super rinse
13. Push to open
14. Interior light at
power off
15. Failure readout
Alternatives
0/1/2/3/4/5/6/7/8/9
On/Off
0 ml - 40 ml
On/Off
On/Off
On/Off
Adjusting the water softener. Select a setting
depending on the hardness of the water
supply. It is important that this setting is
correct!
See Water hardness in the chapter Before
washing for the first time.
For a water supply with a hardness below
6°dH (10°fH / 7°eH / 1.0 mmol/l), select 0.
The water softener is deactivated and no salt
needs to be added.
Activate this setting when using an all-in-one
detergent that contains rinse aid.
This setting reduces the rinse aid dosage
and affects how often the dishwasher's
built-in softener is regenerated.
Activate this setting if you want to use
automatic dosing of detergent.
The exact dosage depends on which
program is running. For the Auto program,
the dosage also depends on how dirty the
dishes are.
0 ml (Off)
The Super rinse function rinses the dishes an
extra two times.
The program time is extended and the
dishwasher uses more energy and water.
Activated in the following programs:
Universal
Intensive
Quick pro
Hygiene
Plastic
Lower half
Upper half
The dishwasher door can be opened without
a handle.
Select whether the interior light is to be
switched on when the dishwasher is turned
off and the door is opened. (If
on, the interior light is always switched on
when the door is opened.)
Any error messages.
When contacting your service centre, you
may be asked to provide the most recent
error messages.
Settings
is turned
31