Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. Fix each panel mount into place, and then install the panel
mount covers and hinge end caps.
■
Use a Phillips screwdriver and a 9.5 mm screw to fix each
of the panel mounts (four on each door) into place.
■
Snap a panel mount cover onto each panel mount that
is on the side of the door opposite the hinges, and then
snap a hinge end cap onto each hinge.
10. Install the two top screw covers and the four hinge interior
covers. Each snaps into place.
Reverse the Doors
(optional)
1. Use a Phillips screwdriver to remove the four screws on the
top hinge of the refrigerator door. Repeat for the four screws
on the bottom hinge of the refrigerator door.
8
2. If present, remove the hole plugs from the opposite side of
the refrigerator door.
3. Use the four screws to install the top hinge on the opposite
(bottom) side of the refrigerator door. Repeat for the bottom
hinge.
4. Insert the hole plugs where the hinge screws were prior to the
door reversal.
5. Repeat the process to reverse the freezer door.
Complete Installation
1. Remove all boxes, parts packages and packing materials
from the interior of the refrigerator. See the "Cleaning" section
in the Use & Care Guide for instructions.
2. Install the shelves and bins in the refrigerator and freezer
compartments.
3. The controls are preset at the factory to the midpoint setting.
Make sure the compressor is operating properly and that all
the lights are working.
To get the most efficient use from your new built-in refrigerator,
read the Use & Care Guide. Keep Installation Instructions and
Use & Care Guide near the built-in refrigerator for easy reference.
Publicité
Table des Matières
