LEGRAND care NOVO Go Mode D'emploi page 15

NOVO Go
7
Charge NOVO Go
Charge with USB Charger
7.1
1 Connect the USB cable to the AC power adapter and attach the magnetic charger to the back of
NOVO Go.
2 Connect the AC power adapter to the wall socket. NOVO Go gives a short sound.
The battery icon flashes green until the battery is fully charged.
3 If necessary, do a check of the status during the charging, refer to
4 When NOVO Go is fully charged, the battery icon stays on for 1 minute and then it goes off.
User Manual
If NOVO Go is set to off (for example if the battery has not been charged),
it automatically sets to on when you connect to a charger. If the battery
icon slowly flashes red, it is necessary to charge the battery.
NE41 21002-02 v2.0
8.2 Status Check.
13