Publicité
Les langues disponibles
Les langues disponibles
Control Panel Settings
Setting the Clock
1. Touch the CLOCK key. The colon between the minutes
and seconds on the time display will begin to flash.
2. Enter the current time on the number keypad before
the colon stops flashing. For example: For 12:08,
touch 1-2-0-8 on the keypad. Touching the # key
changes the AM-PM indicator.
3. Touch START.
IMPORTANT
• The clock cannot be set during delay timed cooking, if one of
the timers is in use or if self-clean or Sabbath mode is active.
• After a power failure, the time on the display may flash,
indicating that the time may not be correct.
• After touching the clock key, you must enter the time and
touch START soon afterward. If you wait longer than six
seconds between touching keys, the display will go back to
the original setting.
24/12 Hour Clock (Military Time)
The oven is set to 12-hour (non-military) time at the fac-
tory. 24 hour time is also known as military time.
1:36 PM = 13:36 military time.
If you want to switch the clock to 24 hour
time or switch from military back to regular
time:
1. Touch and hold the CLOCK key for six seconds. The
display will indicate the mode the clock is currently set
to, 12 Hr or 24 Hr.
2. Touch the # key to change the clock mode. To leave
the setting as is, do not touch any keys.
3. Touch CANCEL · SECURE to return to the main dis-
play. If you have set the clock to 24 hour time, the
keypad will allow you to enter military time when set-
ting the clock.
Setting the Temperature Scale
You can select the temperature scale (Fahrenheit or Cel-
sius) the oven uses to display the cooking temperature.
The oven is preset at the factory to Fahrenheit.
To change the temperature scale:
1. Touch and hold the BROIL key (under UPPER OVEN
on double ovens) for six seconds.
2. The display will indicate the temperature scale the
control panel is currently set to, "F" or "C".
3. Touch the # key to change the temperature scale. To
leave the setting as is, do not touch any keys.
4. Touch CANCEL · SECURE. The control panel is now
set to the new temperature scale.
Operating Your Oven
Turning the Control Panel "Beep" Off/On
The control panel beeps any time you touch any of the
keys or when various error conditions exist. It also beeps
when a timer is done counting down (page 10) or
whenever the oven performs certain preset functions, for
example, pre-heat is complete. The tone may be silenced
so that it does not function under the above conditions.
To turn the control panel "beep" off (or on):
1. Touch and hold the START TIME key for six seconds,
until "beep" appears on the display.
2. Touch the # key repeatedly to switch between "On"
and "Off."
3. Touch CANCEL · SECURE when the desired mode
appears on the display.
To change the control panel back to the previous mode,
repeat the above steps.
Before You Cook...
•
Dacor recommends turning the oven on for one hour
at 500°F to burn off any residual oils used during the
manufacturing process. Any of these oils left on the
inner parts can cause an undesirable smell the first
few times the oven is used.
•
PRE-HEAT: When you use your oven to bake or
roast, it preheats automatically. The preheat cycle
rapidly brings the oven chamber up to the proper
cooking temperature. It takes several minutes to pre-
heat the oven. Preheat time depends on the tempera-
ture settings. The time may be longer depending on
the type of electrical supply in your community. There
is no preheat cycle for any of the broil modes.
•
After you pull food out of the oven, it will continue to
cook. This process is called "carry-over." The larger
the portion of food, the longer it will cook. It is best to
let the meat rest after it comes out of the oven for 10
to 15 minutes before carving. Doing so will allow the
meat to retain its juices and make it easier to carve.
Do not allow acids (citrus juices, tomato sauces, etc.) to remain
on the oven's surfaces. The porcelain finish may stain or pit.
5
CAUTION
Publicité
