Uline H-6577 Instructions De Montage page 2

Figure 2
Figure 3
Figure 4
Figure 5
1. Clean the table with a cleaner/brightener that
contains mildewcide.
PAGE 2 OF 6
ASSEMBLY CONTINUED
5. Place the preassembled table top upside down.
6. Pre-drill for holes using 1/8" drill bit. Loosely attach
7.
8. Flip the table so it is right side up.
9. Make sure legs are level and tighten all 3½"
10. Attach a seat brace along the center of two seat
11. Place the outside edge of the seat bench flush with
CARE AND MAINTENANCE
2. It is recommended to apply an outdoor wood
1-800-295-5510
uline.com
Position the legs on the inside of the support bar.
Make sure the legs are equal distance from either
table edge and the cross-member is facing out.
(See Figure 2)
legs using four 2½" wood screws through the
pre-drilled holes. Repeat steps to attach the other
leg.
Make sure the legs are perpendicular to the table
top to ensure table top is level. Pre-drill and attach
diagonal braces using four 2½" wood screws to the
cross-member and preassembled table top.
(See Figure 3)
carriage bolts using a 7/16" socket wrench. Tighten
all 2½" wood screws.
planks ensuring the brace is equal distance from
both ends of the seat. Pre-drill holes using 1/8" drill
bit and attach using ten 2½" wood screws on the
brace. Repeat for the second seat plank.
(See Figure 4)
the ends of the seat braces and align the ends of
the bench with the edge of the table top. Use a 1/8"
drill bit to pre-drill holes and avoid splitting. Attach
the seat bench to the braces using eight 2½" wood
screws per bench seat. Repeat for opposite seat
bench. (See Figure 5)
sealer or stain that contains water repellent and an
ultraviolet stabilizer.
0421 IH-6577