Waterpik WP-950 Mode D'emploi page 8

8 All manuals and user guides at all-guides.com
CLEANING AND TROUBLESHOOTING YOUR WATERPIK WATER FLOSSER
®
Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to prevent
clogging by partially filling reservoir with warm water and running unit with
tip pointed into sink until unit is empty.
Excess Power Cord Storage
After determining the length of power cord necessary, push extra cord into
the cavity on the bottom of the unit and insert cord into the retention slots.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when
necessary by using a soft cloth and mild non-abrasive cleanser.
The accessory storage container and the water reservoir are removable for
easy cleaning and are top rack dishwasher safe.
Removing Hard Water Deposits
Hard water deposits may build up in your unit, depending on the mineral
content of your water. If left unattended, it can hinder performance. Cleaning
internal parts: add 2 tablespoons of white vinegar to a full reservoir of warm
water. Point the handle and tip into sink. Turn unit ON and run until reservoir
is empty. Rinse by repeating with a full reservoir of clean warm water. This
process should be done every 1 to 3 months to ensure optimal performance.
Leakage
If leaking due to a damaged hose, please email
InternationalService@Waterpik.com
Service Maintenance
Waterpik Water Flossers have no consumer serviceable electrical items
®
and do not require routine service maintenance. For all your service needs
email Water Pik, Inc. at InternationalService@Waterpik.com. Please do not
ship product to Waterpik International, Inc. offices, this will delay service.
Refer to the serial and model numbers in all correspondence. These
numbers are located on the bottom of your unit.
Still have questions? Email us at InternationalService@Waterpik.com.