Table des Matières
Publicité
ENGLISH
How to maintain
the vacuum cleaner
!
CAUTION
Turn off the switch and unplug the
electrical cord before maintenance.
How to change the dust bag
• Lift up cover latch release and pull off cover
(Fig.1).
• Grasp the clamp on both sides and squeeze to
release the full dust bag (Fig. 2).
• Align new dust bag collar with slots in bag holder
(Fig. 3). Slide bag back into position until it clicks.
• Align tabs at bottom of dust bag cover with slots
(Fig. 4). Press top of cover back toward cleaner
body. Press cover latch down.
Note: Dust bag cover will not latch without a dust
bag installed.
Pre-motor filter
The pre-motor filter is located under the dust bag.
Check this filter each time the dust bag is changed.
• Clean or replace as needed. Shake filter to remove
excess dust. If necessary, wash with water and
mild detergent.
• Reinstall filter after completely dry.
How to replace the HEPA filter assembly
• Step on handle release pedal and lay cleaner flat
for easy access to filter cover.
• Press tab to release HEPA filter cover and lift
cover off.
• Grasp tab and lift out filter.
• Install new HEPA filter.
• Match tabs with slots and press HEPA filter cover
back into place.
Note: Some filters are washable and can be
cleaned by rinsing with warm water. Be sure the
filters are completely dry before installing.
12
www.sanitairecommercial.com
1
3
2
4
Publicité
Table des Matières
