Overview Of The Components; Preparation; Use Instruction - BOMANN KM 398 CB Mode D'emploi

WARNING: Risk of injury!
• Children shall not play with the appliance.
• Appliances can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of
the appliance in a safe way and if they understand the hazards
involved.
CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".
• Do not manipulate safety switches.
• Only process foodstuffs with this appliance.
• Misuse of the appliance for other purposes may cause injury.

Overview of the Components

1 Splash guard
2 Swivel arm
3 Lever for lowering/raising the arm
4 Control knob
5 Motor housing
6 Hook splash guard
7a Dough hook
7b Egg beater
7c Mixing hook
8 Mixing bowl
9 Drive shaft

Preparation

• Remove the appliance and all included accessories from
the box.
• In order to remove any production residue, clean all acces-
sories before initial use as described under "Cleaning".
Electrical Connection
• Ensure that your mains power corresponds with the specifi-
cations on the type label.

Use Instruction

1. Opening the swivel arm: Press the lever (3). Manually
guide the swivel arm to the top position.
KM398CB_IM_new_Nov.2015
2. If you need the splash guard, attach it now to the swivel arm
from below. Hold the splash guard (1) in such a way that
the fill opening is positioned in front of you. On the bottom
of the swivel arm, there are two recesses on the front and
back. Insert the splash guard with its guide lugs into these
recesses. Turn the splash guard towards
lock it.
3. If you want to use the dough hook (7a) or mixing hook (7c),
first attach the hook splash guard (6). It will prevent the
drive shaft (9) from getting in contact with the dough.
Hold the guard like a bowl. Insert the dough hook or the
mixing hook from below through the recess of the guard
and then lock it by turning it one quarter of a turn.
4. Attaching accessories: On the
top end of the accessories, there
is a recess for the drive shaft and
the splint. Slide the accessory
over the drive shaft. Push down
and at the same time turn the
accessory anticlockwise in order
for the splint of the drive shaft to lock into the accessory.
5. Mixing bowl: Place the mixing bowl into its holder. Turn the
bowl towards LOCK to its limit.
6. Fill your ingredients into the mixing bowl.
7. Check whether the control knob is set to "0".
8. Press the lever (3) to lower the arm. You must press onto
the arm from above, until it locks into the lowest position.
9. Connect the mains plug to a tested plug socket.
10. Select the speed using the table below.
LOCK to
31
19.11.2015