Publicité
Les langues disponibles
Les langues disponibles
3) Testing
To test the DBM guide you need to carry out the folloleaf checks:
1. Slide the leaf along its entire length, making sure that the sliding
carriage is not subject to any extra friction at any point.
2. Slide the leaf along its entire length, making sure that the post is
not subject to any lateral or crosswise thrusts other than those
resulting from the normal sliding of the carriage.
4) Maintenance
Scheduled routine maintenance must be performed in order to ensu-
re the long life of the DBM guide, at least every 6 months.
1. Check all the materials of the DBM guide for signs of wear; wat-
ch out for possible erosion or oxidation of the aluminium guide,
post and related fasteners.
5) Disposal
The DBM guide is made up of various types of materials some of
which can be recycled, such as aluminium and the electrical cables;
other materials must be disposed of as waste, including the cable
holding chain which is made of plastic.
6) Technical characteristics
In order to improve its products, Nice S.p.a reserves the right to modify their technical characteristics at any time without prior notice, whi-
le always guaranteeing their functionality and fitness for the intended purpose.
All the stated technical characteristics refer to an ambient temperature of 20°C (±5°C)
Caratteristiche guida mobile DBM
Type
Available versions
Total length of guide
Maximum leaf travel
Electrical cable length
Type of cable supplied
Cable resistivity
Guide colour
No. of manoeuvres
Use in highly acid, saline or potentially
explosive atmosphere
Operating temperature
Dimensions / weight (including the accessories)
4
All manuals and user guides at all-guides.com
3. Trigger the sensitive edge repeatedly, making sure that the detec-
4. Perform all the required tests and checks on the sensitive edge
2. Perform all the tests and checks described in the "Testing" sec-
1. Disassemble the DBM guide folloleaf the procedure described in
2. Separate as best you can the parts that can or must be recycled
3. Sort the various materials and consign them to local authorized
Electrical connection device for safety sensitive edges installed on moving leaf
DBM5
5m
4,87m
9m
>100.000 (in the absence of powders and properly installed )
33x73 L5000 / 6,5Kg
tion unit switches from the active mode (ON) to the alarm mode
(Off) every time. Slide the leaf along its entire length a number of
times, making sure that the detection unit remains in the active
mode (On) all the time.
and the detection unit.
tion.
the "Installation" chapter, but in the reverse order.
from those that must be disposed of otherwise.
recycling and disposal centres.
DBM7,5
7,5m
7,37m
11,5m
4x0,22mm
2
800mΩ/m
Silver tone anodization
No
-30 ÷ 70°C
33x73 L7500 / 9,2Kg
DBM10
10m
9,87m
14m
33x73 L10000 / 11,8Kg
Publicité
