14
Model: CA60
Alabaster Glass
Attach glass (9) to mounting
bracket for glass (3) using
washer (3), nut (3) and finial
(13) as shown in diagram
below.
15
Model: CB60
Etruscan or Sandstone Glass
Attach glass (9) to mounting
bracket for glass (3) using
washer (3), nut (3), cap (13)
and finial (13) as shown in
diagram below.
All manuals and user guides at all-guides.com
Step 14
Glass (9)
Washer(3)
Nut (3)
Finial (13)
Step 15
Glass (9)
Washer (3)
Nut (3)
Cap (13)
Finial (13)
16
Wiring Instructions/Instrucciones de cableado
NOTE: Use instructions packed with celing fan to wire ceiling fan.
WARNING: To avoid overheating and possible damage to his device and
other equipment, do not install to control a receptacle, fluorescent lighting,
transformer, or motor-operated appliance other than the fans for which this
control is intended. Use this device only with copper or copper clad wire.
With aluminum wire use only devices marked CO/ALR.
1. Remove insulation to expose 3/4" bare copper wire at end of circuit
conductors. Keep wire ends straight.
2. Connect wires per wiring diagram as follows: black leads (one each) to
black (hot) line, green ground wire to copper outlet wire. Hold bare
ends together. Push wires firmly into wire connector. Screw connector
on clockwise until no bare copper shows. Secure connector with electrical
tape. CAUTION: Never attach white neutral wire to TCS+ Control
3. Make sure battery is properly installed in switch. The switch should
already have this preinstalled, but double check before installing the
mounting plate (see diagram). Note: The battery replacement code is
23A 12Volt.
4. Mount device with long mounting screws (provided). Install wallplate
and tighten cover screws.
5. Restore power at circuit breaker or fuse. Installation is complete.
Load
(Black Wire)
23A 12Volt
Battery
HI
L-1
MED
L-2
LOW
REV
OFF
1 2 3 4
ON
12V. BATT.
SUPER
23A 12V
OFF
ON
Ground Wire
Hot Line
(Green Wire)
(Black Wire)
Ground Wire
(Copper Wire)
Neutral
(White Wire)
SINGLE POLE
Neutral
(White Wire)