Homelite HHC50LP Manuel Du Propriétaire page 13

Ignitor
1. Remove motor and fan
guard from heater (see
Motor, page 11, steps 1
through 5).
2. Remove black ignitor wire
from piezo ignitor. Access
ignitor wire through
underside of heater base
(see Figure 11). Push wire
up through bushing in
heater shell.
3. Remove ignitor mounting
screw from rear head
using nut-driver or stan-
dard screwdriver (see
Figure 12).
4. Remove ignitor from rear
head.
5. Install new ignitor. Attach
ignitor to rear head with
ignitor mounting screw.
6. Run ignitor wire from new
ignitor through bushing in
heater shell. Attach ignitor
wire to piezo ignitor.
7. Set gap between ignitor
electrode and target plate
to 4.32 mm (.17") (see
Figure 13).
8. Test for spark.
WARNING: Make sure
heater is disconnected
from propane supply.
Heater could ignite
causing severe burns.
Push piezo ignitor button
and watch for spark
between ignitor electrode
and target plate.
9. Place motor and fan guard
into rear of heater shell
(see Motor, page 12, steps
12 through 16).
101497
Ignitor Wire
Figure 11 - Removing Ignitor Wire from Piezo Ignitor
Rear
Head
Ignitor
Mounting
Screw
Figure 12 - Removing Ignitor Mounting Screw and Ignitor
Figure 13 - Clearance between Ignitor Electrode and Target Plate
Piezo Ignitor
Bushing
Ignitor
Target
Plate
Gap
Area
Ignitor
Electrode
Underside of
Heater Base
13