Control Panel Details - Sabiana Energy Smart ENY SHP-130 Instructions D'installation, D'utilisation Et D'entretien

LEGEND:
Item
N-L-PE 230 Volt power terminals
F Fuse 5x20
FAN 1 230 Volt Power Supply - Supply fan V1
FAN 2 230 Volt Power Supply - Extraction fan V2
F1 0-10 Volt Signal - Fan V1
F2 0-10 Volt Signal - Fan V2
B1 - B4 Temperature sensors
CONTROL
T-EP wall-mounted controller
T-EP
DGTO Digital output contact
C1-C1 NO dry input contact
C3-C3 NC dry input contact (active only if JUMPER MC4 is open)
FC-FC SPST Dry output contact
IAQ Internal Relative Humidity Sensor
RS485-A Serial A network connection
RS485-B Serial B network connection
MC3 Power board service jumper
MC5 Serial A network jumper
EH1 Electric duct Pre-Heating PWM control output
EH
DL1 Power on LED
KNX KONNEX communication
DY1 Board display
KP1 " - " key
KP2 " ENTER " key
KP3 " + " key
PE MOTOR EC motor earthing protection
***
B1 Fresh air temperature probe
B2 Supply air temperature probe
B3 Extracted stale air temperature probe
B4 Exhaust air temperature probe

CONTROL PANEL DETAILS

DY1
KP1
KP2
Description
Probes
F130 .
LED
KP3
/
/
/
/
/
/
***
see table below
OPTIONAL ( accessory not supplied with the unit)
Signal for external enabling or for controlling valves equipped with solid state
relay
trnF
• Remote On/Off " " function – unit Off when the contact is closed
bSt
• Booster " " function - Booster function active when the contact is closed.
See Fireplace and Boiler functions
Remote alarm or external enabling signal
/
SLAVE modbus port for connection to supervision Master devices.
SLAVE modbus port for connecting Master devices + 12V power supply
/
The network must be closed on the last unit in case of RS485 connection. It is
closed by closing Jumper MC5.
/
Signal necessary to detect the error status of the antifreeze element
/
Towards interface expansion board with KNX supervision systems
/
/
/
/
/
Notes
English
73